Please wait while the page loads...

What could cause the check engine light to come on in a Toyota Tacoma?

When your check engine light comes on, this could be as easy as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a harsh problem that could cause harsh damage to your engine and come with a generous repair bill. Depending on your make and model, the check engine light will illuminate or blink. A logical glow typically means something fewer harsh but a flashing check engine light expresses that your vehicle’s engine is in harsh trouble and service is needed straightaway. If your check engine light is flashing in your Toyota Tacoma, we highly recommend not to drive the vehicle and schedule Toyota service today. Below is a list of the most environmental reasons your check engine light can come on:

  • The battery is poor or dead. The battery in your Toyota Tacoma is every large. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did assorted decades ago, and they don't really require maintenance. The value of a new one depends on the type of Toyota you drive, but check our extant service coupons and specials.
  • Your catalytic converter is damaging or going damaging. The catalytic converter is a part of your Toyota Tacoma’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is ordinarily caused by neglected maintenance, which is why Nalley Toyota Union City offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it repaired, your Toyota Tacoma will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause substitute problems from overheating.
  • Your Toyota Tacoma has a vacuum leak. Every Toyota Tacoma has a vacuum system that performs a wide variety of functions. The vacuum system also helps decrease harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dehydrated out and crack, especially if they’re exposed to important heat or extreme cold.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota Tacoma is what determines how much fuel is needed to run your engine efficiently by measuring the deposit of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to explicit changes, like altitude. If your Toyota Tacoma is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a damaging mass airflow sensor.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or substitute item can wreak havoc on your Toyota Tacoma if it’s not installed appropriately. These aftermarket components and accessories can drain the battery, trigger the check engine light, or even avoid the vehicle from starting. If these issues sound noted, bring your Tacoma to Toyota and have our team of certified mechanics ensure that your aftermarket items were installed well and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM components first place might cost a small bit more but could save you money from having to get scanty work and damage caused by scanty installation work corrected.
  • One of the most classic and frequent cause is that your Toyota Tacoma gas cap is loose, damaged or missing. The gas cap for your Toyota Tacoma serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a damaging fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't fancy. If your check engine light turns on immediately after you put gas in your Toyota Tacoma, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the deposit of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less compelling when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your Toyota Tacoma's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the right collection of air and fuel that enters the cylinders in your engine. A damaging O2 sensor can also cause a car to fail an emissions test.
  • New Spark Plugs or Plug Wires are needed for your Toyota Tacoma. The spark plugs are the part of your engine that ignites the air/fuel collection in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires transport the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are damaging or old, you will experience scanty performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, main to more fancy repairs.

Toyota Tacoma Check Engine Light Flashing

Although there are bountiful capacity causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are countless daily causes encompassing something as straightforward as a loose gas cap. Substitute daily reasons for a Check Engine Light are a malfunction with the fuel injection system, dirty mass airflow sensor, faulty emissions control part, damaged oxygen sensor, faulty head gasket, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was fixed.

Every Toyota Tacoma was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its crucial systems. The sensors are continually detecting conditions while sending data to the computerized control department. If the computerized control department detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what definitely is erroneous nor what to do about it. That’s where we come in; Nalley Toyota Union City provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Exceedingly Qualified Service active.

Will the check engine light reset itself?

The check engine light on your Toyota Tacoma will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going logical, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Toyota Tacoma light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to deliver it in to Nalley Toyota Union City so the light and code can be double-checked and reset.

Check Engine Light Service Toyota Tacoma

What do you do when you’re driving along in your Toyota Tacoma and swiftly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the automobile over to the side of the road and call a tow truck, but it is recommended that you get your Toyota Tacoma checked as soon as plausible. Ignoring that warning could end up causing major damage to expensive engine components.

When your Toyota Tacoma's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t meager, a computer turns on your check engine light. This amber or yellow light is commonly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic investigate tool that is used by our Toyota auto repair technicians at Nalley Toyota Union City. There are also a number of relatively low-cost code readers that are designed for do-it-yourselfers, should you opt for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an competent professional to mean the issue and repair it.

Is it safe to drive your Toyota Tacoma with the check engine light on?

This question is not very pure because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is typically indicated by a persistent glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more unhealthy problem. If the check engine light is flashing, this means that there is a unhealthy issue and it is recommended to service your Toyota Tacoma shortly. Call the experts at Nalley Toyota Union City by dialing 7702848361 so you can describe the issues. Or reduce your speed and transport your Toyota to our certified mechanics as soon as feasible.

Toyota Tacoma Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Tacoma. There are hundreds of chance codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you likely knowledge about your vehicle and will also allow that Check Engine Light to do what it is precisely supposed to do: be your guide. Unfortunately, noticeable and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of likely OBD codes, there are also hundreds of likely reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Bad Spark Plugs
  • O2 Sensor
  • Transmission issues
  • Computer output circuit issues
  • Fuel and air metering systems problems
  • Ignition system faults
  • Emissions controls issues
  • Old Battery

This is why it is imperative for someone who does not have assorted of automotive knowledge to not assume what a code means. If the engine light comes on due to a unhealthy concern, you risk damaging your car supplemental by not repairing the issue right away. When your check engine light comes on, you should get it checked out promptly by a certified Toyota mechanic. Call Nalley Toyota Union City at 7702848361 today or schedule your check engine light service online today!

Toyota Tacoma Check Engine Light

If the check engine light in your Toyota Tacoma starts flashing, that means that the problem needs prompt attention and your Toyota should be brought in rapidly. A flashing light suggests that the problem is hazardous and if not taken care of rapidly may result in potent damage to the automobile. This blinking light typically indicates a exacting engine misfire allowing unused fuel to be ditched into the exhaust system. There it can quickly enhance the temperature of the catalytic converter to a point where damage is possible, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, long-established or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our department of automotive experts at Nalley Toyota Union City instantly by calling 7702848361.

What Does the Check Engine Light Mean?

One of the most usually misunderstood lights or indicators in your Toyota Tacoma is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few other ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your car. Onboard computers increasingly have controlled and monitored car performance since the 80s and do a variety of things for your Toyota Tacoma. Some of these include ignition timing, shifting automatic transmissions controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of several things. It can be as indisputable as your gas cap being loose or as hazardous as engine knocking. If your check engine light is on in your Toyota Tacoma, contact Nalley Toyota Union City. Contact Nalley Toyota Union City today! Our Toyota service department can help you find out what code is turning your check engine light on or inspect why your check engine light is flashing.

How many miles can you drive with the check engine light?

It could be anything from a bad sensor to plug wires needing to be interchanged. Since each check engine code has its own level of severity, it is difficult to predict how bountiful miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is flashing, we recommend that you pull over and contact Nalley Toyota Union City to aid find out if your vehicle is safe to drive in or if we recommend a tow truck.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not accurately tightened to a more unhealthy failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it positive to get the accessible code reading and diagnosis. The middle estimate for a check engine light diagnosis & testing is generally between $88 and $111. The positive news, Nalley Toyota Union City offers complimentary multi-point inspections and free diagnostics, in most cases, to help opt for the cause of your check engine light.