Please wait while the page loads...

What could cause the check engine light to come on in a 2019 Toyota Tacoma?

When your check engine light comes on, this could be as easy as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a tough problem that could cause tough damage to your engine and come with a humongous repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow constantly means something fewer tough but a flashing check engine light illustrates that your vehicle’s engine is in tough trouble and service is needed immediately. If your check engine light is flashing in your 2019 Toyota Tacoma, we highly suggest not to drive the vehicle and schedule Toyota service today. Below is a list of the most prevalent reasons your check engine light can come on:

  • Issues with any aftermarket items. An aftermarket alarm, exhaust or distinctive item can wreak havoc on your 2019 Toyota Tacoma if it’s not installed subsequently. These aftermarket parts and accessories can dump the battery, trigger the check engine light, or even stop the vehicle from starting. If these issues sound common, bring your Tacoma to Toyota and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might cost a small bit more but could save you money from having to get poor perform and damage caused by poor installation perform corrected.
  • New Spark Plugs or Plug Wires are needed for your 2019 Toyota Tacoma. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires transport the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or departed, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, leading to more lavish repairs.
  • Your 2019 Toyota Tacoma has a vacuum leak. Every Toyota Tacoma has a vacuum system that performs a giant variety of functions. The vacuum system also helps lower destructive emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to notable heat or extreme rapid.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the discard of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less productive when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2019 Toyota Tacoma's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to pick the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • One of the most normal and frequent cause is that your 2019 Toyota Tacoma gas cap is loose, damaged or missing. The gas cap for your 2019 Toyota Tacoma serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is departed or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't lavish. If your check engine light turns on hastily after you put gas in your 2019 Toyota Tacoma, first thing you should check is to make confident the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • The battery is low or dead. The battery in your 2019 Toyota Tacoma is every vital. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The price of a new one depends on the type of Toyota you drive, but check our modern service coupons and specials.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2019 Toyota Tacoma’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is ordinarily caused by neglected maintenance, which is why Nalley Toyota Union City offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it repaired, your 2019 Toyota Tacoma will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause distinctive problems from overheating.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota Tacoma is what determines how much fuel is needed to run your engine efficiently by measuring the discard of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to clear changes, like altitude. If your Toyota Tacoma is having trouble starting, idling rough or has a quick change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.

How many miles can you drive with the check engine light?

Since each check engine code has its own level of severity, it is difficult to predict how innumerable miles you can drive with the warning light on. If you check engine light is twinkling, we recommend that you pull over and contact Nalley Toyota Union City to assist find out if your car is safe to drive in or if we recommend a tow truck. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a bad sensor to plug wires needing to be interchanged.

2019 Toyota Tacoma Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that miniature light on your vehicle’s dashboard suddenly lights up, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Tacoma. There are hundreds of disparate codes that your check engine light can represent. While that sounds daunting, with a miniature patience, tackling middle diagnostics will give you fundamental knowledge about your vehicle and will also allow that Check Engine Light to do what it is truly supposed to do: be your guide. Unfortunately, practical and fundamental vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of attainable OBD codes, there are also hundreds of attainable reasons for the light, including:

  • Bad Spark Plugs
  • Ignition system faults
  • O2 Sensor
  • Computer output circuit issues
  • Fuel and air metering systems problems
  • Emissions controls issues
  • Transmission issues
  • Loose Gas Cap or Missing Gas Cap
  • Old Battery

This is why it is alarming for someone who does not have a lot of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out promptly by a certified Toyota mechanic. Call Nalley Toyota Union City at 7702848361 today or schedule your check engine light service online today! If the engine light comes on due to a strict concern, you risk damaging your car further by not repairing the issue right away.

Check Engine Light Service 2019 Toyota Tacoma

What do you do when you’re driving along in your Toyota Tacoma and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t indicate you have to pull the vehicle over to the side of the road and call a tow truck, but it is recommended that you get your 2019 Toyota Tacoma checked as soon as conceivable. Ignoring that warning could end up causing imposing damage to expensive engine components.

When your 2019 Toyota Tacoma's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electrical control system that it can’t honorable, a computer turns on your check engine light. This amber or yellow light is regularly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic diagnose tool that is used by our Toyota auto repair mechanics at Nalley Toyota Union City. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you designate that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to pick the issue and repair it.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is mostly between $88 and $111. The marvelous news, Nalley Toyota Union City offers complimentary multi-point inspections and free diagnostics, in most cases, to help choose the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more treacherous failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it marvelous to get the accessible code reading and diagnosis.

Will the check engine light reset itself?

The check engine light on your 2019 Toyota Tacoma will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2019 Toyota Tacoma light will go off after about 20-40 miles. If you drive over that deposit and the light is still on, you will need to deliver it in to Nalley Toyota Union City so the light and code can be double-checked and reset.

2019 Toyota Tacoma Check Engine Light

If the check engine light in your 2019 Toyota Tacoma starts twinkling, that means that the problem needs sudden attention and your Toyota should be brought in instantly. A twinkling light hints that the problem is relentless and if not taken care of instantly may result in essential damage to the automobile. This blinking light ordinarily indicates a relentless engine misfire allowing unburned fuel to be discarded into the exhaust system. There it can hastily raise the temperature of the catalytic converter to a point where damage is likely, requiring an pricey repair. Some owners ask if spark plugs cause the check engine light to flash? This can really be the cause. A destructive, traditional or dirty spark plug can cause the engine to misfire. If your check engine light is flashing, please contact our team of automotive experts at Nalley Toyota Union City rapidly by calling 7702848361. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a highly expensive repair.

2019 Toyota Tacoma Check Engine Light Flashing

Although there are innumerable possible causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are various amiable causes including something as easy as a loose gas cap. Diverse amiable reasons for a Check Engine Light are damaged oxygen sensor, faulty head gasket, a malfunction with the fuel injection system, faulty emissions control part, dirty mass airflow sensor, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as essential to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was fixed.

Every 2019 Toyota Tacoma was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its stern systems. The sensors are continually detecting conditions while sending data to the electronic control company. If the electronic control company detects that the data is out of factory specifications, the Check Engine Light lights up telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what specifically is wrong nor what to do about it. That’s where we come in; Nalley Toyota Union City provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Extremely Qualified Service professional.

What Does the Check Engine Light Mean?

One of the most continuously misunderstood lights or indicators in your 2019 Toyota Tacoma is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few chance ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light brightens in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a collection of things for your 2019 Toyota Tacoma. Some of these include controlling engine speed, ignition timing, shifting automatic transmissions and implementing stability control, just to name many. With that being said, the check engine light can indicate a variety of other things. It can be as convenient as your gas cap being loose or as serious as engine knocking. If your check engine light is on in your 2019 Toyota Tacoma, contact Nalley Toyota Union City. Contact Nalley Toyota Union City today! Our Toyota service department can assist you find out what code is turning your check engine light on or audit why your check engine light is flashing.

Is it safe to drive your 2019 Toyota Tacoma with the check engine light on?

This question is not particularly uncomplicated because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is continually indicated by a common glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more perilous problem. If the check engine light is blinking, this means that there is a perilous issue and it is recommended to service your Toyota Tacoma hastily. Call the specialists at Nalley Toyota Union City by dialing 7702848361 so you can describe the issues. Or lower your speed and transport your 2019 Toyota to our certified mechanics as soon as likely.